Tag - Electric fence energisers

Energisers and Batteries

Electric Fence Energisers and batteries

speedrite s60 energiserThe Speedrite range of electric fence energisers is a breakthrough in electric fence technology. They are solid state which means the components are very hardy and can withstand being dropped, stood upon or immersed in water.

The optimum type of shock to safely contain horses should be a very short but extremely high voltage pulse – similar to a bee sting. Horses do not feel anything below 3,000 volts. For safety, the power through the fence should be 5-8,000 volts. In our experience, the most suitable and reliable electric fence energiser units are those manufactured by the New Zealand firm of Speedrite (Tru-test).

'S range' energisers can be run from either mains or battery. The ideal battery is a 12 volt, 85 amp hour leisure unit. Dependant on use and size of energiser, a battery can last up to three weeks between charges.

Except for the AN90S, earthing rods are not included in any prices.

The Speedrite range of electric fence energisers carries a two-year warranty.

Fieldguard electric Fencing

Hints on Electric fence Installation

Fieldguard electric Fencing

Hints on Installation

Insulated sprung gate handle – R11

A few basic rules

A few basic rules need to be followed when installing and using the Fieldguard system.

Installing Fieldguard electric tape

Installing electric fence tape

The 40mm tape requires a support every 5m; 20mm tape requires a support every 7m. As tape is light it requires the thinnest line stakes possible.

Insulators

Fixing insulators

When secured to wood posts, it is recommended that the insulators (R8) are screwed (R8X) on using a Philips screwdriver or, much the best, a cordless screwdriver.

Insulators

Insulators on glass fibre fence stakes

When putting the insulators (R8) onto the glass fibre stakes (R7), always use a heavy club mallet. It is also wise to wear protective glasses.

R13 Extended Insulator

Fixing extended insulators

The R13 insulators are hammered into the side of existing wood stakes and can be quickly removed with a claw hammer.

Insulated sprung electric fence gate handle – R11

Gate handles

When attaching tape to the gate handle, first feed tape through the flat rings and then feed it back through the middle of the two rings.

tensioner

Tensioners

The tensioners (R36V) and corner insulators (R45V) have large flanges at the top and bottom. These should be ignored as they are moulded for North American use.

Making a T-Junction

To make a T-junction in a wide tape run loosen the run and take one insulator away from the fence at the required point, substitute a tensioner (R36V) with the T-junction wire (R36T) already in place in the tensioner.

Tensioners

Corners

The R36V tensioner is used for all normal corner applications, including R13 extended insulator runs.

teflon insulated multi-core cable

Connecting power

Never apply power directly to a tape as it will burn through the filaments in time. A power connector (R59C) should be used to connect power between tapes.

40mm Electric Fence Tape joining buckle – R24

Buckles

To join tape with a buckle, follow the same procedure on each side of the buckle.

Live Electric Fence Warning sign – R27

Avoiding theft

Battery energisers in fields are a ready target for thieves. It is advisable to hide them under old upturned dark-coloured buckets.

R59C connector with R11 Gate Handle and R8 Insulator

Preventing rust

The high voltage combines with the nylon in the tape to produce a mild form of chlorine gas that attacks and oxidises all metals.